Fluid Flow Analysis of Jacket Cooling System for Marine Diesel Engine 93 Kw

Aguk Zuhdi Muhammad Fathallah, Wolfgang Busse, Fadhil Rizki Clausthaldi

Abstract


The main function of cooling system is to control the temperature in the engine. To know the flow in the jacket cooling system for marine diesel engine 93 KW and the couple simulation between 1D modeling and 3D modeling, the methodology used. The analysis process was performed by using 3 diffrent softwares. The methodology to analysis fluid flow is CFD (computational fluid dynamic) with steps were problem identification, literature study, design the jacket cooling system based on the cummin diesel engine 93 KW, 1D modeling of cooling system, 3D modeling fluid flow in jacket cooling system, and conclusion. The input of 3D jacket cooling simulation are mass flow, fluid temperature, wall temperature, and heat transfer. The result from this bachelor thesis is fluid flow in jacket cooling system and another parameter output such as temperature flow and velocity if fluid in the jacket cooling system. The result of the flow in jacket cooling is much turbulance in various are of jacket cooling its mean the jacket cooling have a good enfficiency of heat transfer, and the fluid temperature show the increasing temperature from inlet to outlet because of heat transfer happen in the jacket cooling between wall of jacket cooling and fluid. The engine speed will affect the cooling system, if the engine speed is increasing, the speed of flow will increase because the cylinder block need more coolant and the temperature of cylinder block will increase

Keywords


jacket cooling system; fluid flow; simulation; 3D modeling

Full Text:

PDF

References


A.M. Kriger, M.E. Diskin, M.E. Diskin, Liquid Cooling of Automotive Engine, Mashinostroenie, Moscow, 1985.

U.S Department of Energy, Thermodynamic, Heat Transfer, and Fluid Flow, Volume 1-3, Washington, June 1992

J. H. Ferziger and M. Peric, Computational Methods for Fluid Dynamics. Springer, 1996.

Mohammadi A and Yag houbi, 2011, Two Phase Flow Simulation for Subcooled Nucleat Boiling Heat Transfer Calculation in Water Jacket of Diesel Engine, Vol 2, Spring 2011

Mulemane, A., Soman, R.,2007, "CFD Based Complete Engine Cooling Jacket Development and Analysis", SAE 2007-01-4129.

Alexey Vdovin, 2010, Cooling performance simulations in GT-Suit, Chalmers Reproservice, Göteborg, Sweden 2010




DOI: http://dx.doi.org/10.12962/j25481479.v1i2.2028

Refbacks

  • There are currently no refbacks.


Abstracted / Indexed by:
      
  

 

 

 

 

 

P-ISSN: 2541-5972   

E-ISSN: 2548-1479

 

Lisensi Creative Commons

IJMEIR journal published by  Department of Marine Engineering, Faculty of Marine Technology, Institut Teknologi Sepuluh Nopember Surabaya Indonesia under licenced Creative Commons Attribution-ShareAlike 4.0 International Licence. Based on https://iptek.its.ac.id/index.php/ijmeir/