Pushover Analysis Pile of ULA Jacket Platform Towards Earthquake Loads by SNI-1726:2012

Dirta M Chamelia, Alim B Prakoso, . Silvianita

Abstract


This study aims at analyzing pushover on pile jacket structure based on SNI-1726:2012 standards for earthquake loads. Push­over analysis or ultimate strength was performed on ULA jacket plat­form operated by PHE ONWJ. The jacket platform is operated in the northwestern part of the Java Sea. Design of earthquake loads on ULA jacket platform structure with large seismic accele­ration was obtained. From seismic analysis, dynamic response occurred on ULA jacket platform is evaluated, with natural struc­ture period of 1.256 seconds. The largest shear base values were in X and Y directions resulted from seismic acceleration of PGA 0.2g. On member check, the critical part happens to be one of the members of WD2, and on joint check, the largest UC occurred on 401L joint, both were due to the aforementioned earth quake ace­leration. Pushover analysis was then performed to obtain the value of RSR (Reserve Strength Ratio). The analysis yields an RSR value which far exceed the limiting criteria of API RP 2A WSD of RSR ≥ 0.8. Therefore it could be concluded that ULA jacket platform structure is within the range of low consequence category.


Keywords


jacket platform; seismic; ultimate strength; push¬over; PGA; RSR

Full Text:

PDF

References


Hastanto, E.S: Analisa ultimate strength struktur jacket LE berbasis keandalan. Final Project, Jurusan Teknik Kelautan, FTK-ITS, Surabaya

Soegiono: Teknologi Produksi dan Perawatan Bangunan Laut. Penertbit Airlangga, Surabaya

Murtedjo, M., Djatmiko, E.B. and Sudjianto, H.: The influence of buoyancy parameters on the dynamic behavior of articulated tower. Jurnal Mekanikal, UTM, No. 19, pp. 32-47, June 2005

BSN: Tata Cara Perencanaan Ketahanan Gempa untuk Struktur Bangunan Gedung dan Non Gedung, SNI-1726:2012, Badan Standarisasi Nasional, Jakarta, 2012

BSN: Beban Minimum untuk Perancangan Bangunan Gedung dan Struktur Lain, SNI-1727:2013, Badan Standarisasi Nasional, Jakarta, 2013

API: Recommended Practice for Planning, Designing, and Constructing Fixed Offshore Platforms – Working Stress Design, (API RP 2A WSD), 21st Ed. American Petroleum Institute, Washington D.C.

Health and Safety Executive: Target Levels for Reliability-Based Assessment of Structure during Design and Operation, Norwich, 1999

Rosyid, D.M. and Caldwell, J.B.: Design approach and dimensional similarity in lay-out optimization of structural systems. Computers & Structures, 40 (5), pp. 1125-1137, Jan. 1999

Wisudawan, A., Rosyid, D.M. and Baihaqie, M.: Reliability Analysis of APN-A Offshore Jacket Using Monte Carlo Finite Element Method. Applied Mechanics and Materials, V862, pp. 259-264, 2017




DOI: http://dx.doi.org/10.12962/j2580-0914.v1i1.2875

Refbacks

  • There are currently no refbacks.


Contact:

IJOCE Editor

Department of Ocean Engineering

Institut Teknologi Sepuluh Nopember (ITS)

Kampus ITS - Sukolilo

Surabaya 60111 - Indonesia 

Phone/Fax: +62-31-592 8105

e-mail: ijoce@oe.its.ac.id

Creative Commons License
International Journal of Offshore and Coastal Engineering by Department of Ocean Engineering is licensed under a Creative Commons Attribution-ShareAlike 4.0 International License.
Based on a work at http://iptek.its.ac.id/index.php/ijoce/index.