Analysis of Dynamic Inertia Forces at Main Bearing of Ship Reciprocating Engines

A. Zubaydi Zubaydi, M. Ariana Ariana, L. Baliwangi Baliwangi, A. A. Masroeri Masroeri, F. Louhenapessy Louhenapessy, M. Tukan Tukan, S. M. Taribuka Taribuka

Abstract


During operation, a ship reciprocating engine will vibrate due to the force resulting from the cycle movement of the dynamic components. Soon or later, the vibration will cause wear of engine components. Therefore, the cause of vibration should be early identified so that the propagation of wear can be anticipated. The study modeled the ship reciprocating engine as a two stroke engine, and analyzed one of the causes of the engine vibration, i.e. the force acting on main bearing, using a numerical simulation. An experimental study was also carried out for measuring the acceleration of vibration response due to the numerical dynamic inertia force. The results showed that the dynamic inertia force acting on the main bearing is the main cause of the vibration of engine.

Keywords


acceleration; dynamic inertia force; engine; main bearing; vibration

Full Text:

PDF

References


Astashev V. K., Babitsky V. I., and Kolovsky M. Z., 2000, “Dynamic and control of machines”, CIP Data Applied for: Die Dwtsche Bibliothek - CIP - Eiaheitsaufnahme, New York.

Cho S. H., Ahn S. T., and Kim Y. H., 2002, “A simple model to estimate the impact for induced by piston slap”, Journal of Sound and Vibration.

Inagaki M., Kawamoto A., and Aoyama T., 2002, “Prediction of structural and kinematic coupled vibration on internal combustion engine”, Research Report, Academic Society: The Japan.

Tugiman, 2006, “Analisis dinamik gaya goyang motor bakar satu silinder dengan bantuan perangkat lunak Matlab,” Jurnal Sistem Teknik Industri Volume 7, No. 1 Januari 2006.

Chen Y., Zhiyong H., and Guangtal Z., 2009, “Balance mechanism design of single cylinder engine based on continues mass distribution of connecting rod“, Journal: College of Mechanical Energy Engineering, Zhejiang University, Hangzhou 310027,

China.

Giancarlo G., 1950, “Vibration of structures and machines”, Dipartimento di Maccanica Politecnico di Torino Carco Duca Degli Abruzzi, 24 10129 Torino, Italy.




DOI: http://dx.doi.org/10.12962/j20882033.v21i4.50

Refbacks

  • There are currently no refbacks.


Creative Commons License

IPTEK Journal of Science and Technology by Lembaga Penelitian dan Pengabdian kepada Masyarakat, ITS is licensed under a Creative Commons Attribution-ShareAlike 4.0 International License.
Based on a work at https://iptek.its.ac.id/index.php/jts.