Thermal Stability Analysis of Cyperus Rotundus L Reinforced HDPE Composite in Polymer Composite Roof Tiles

Muhammad Fakhri Hamzah; Budhi Martana; Fahrudin Fahrudin; Armansyah Armansyah; Fitri Wahyuni

doi:10.12962/j25481479.v9i2.20340

Thermal Stability Analysis of Cyperus Rotundus L Reinforced HDPE Composite in Polymer Composite Roof Tiles

Muhammad Fakhri Hamzah, Budhi Martana, Fahrudin Fahrudin, Armansyah Armansyah, Fitri Wahyuni

Abstract

One of the materials that may be utilized in polymer matrix composites is high-density polyethylene (HDPE) plastic. Large amounts of HDPE plastic waste can harm the environment. Therefore, a solution is needed to overcome this problem. One solution to reduce plastic waste is to utilise it into polymer composite roof tiles. Roof tile surfaces are subjected to the greatest amount of solar heat radiation. This study aims to analyze the effect of variations in the composition of HDPE and teki grass on the value of solar radiation heat transfer and the value of thermal stability in polymer composite roof tiles. This research uses an experimental method by composites HDPE and teki grass with variations in the weight of teki grass used by 0%, 10%, 15%, and 20%. The results show that 20% teki grass composition in the composite produces low radiant heat compared to 0% teki grass composition which tends to be higher. according to the findings of the thermal stability test., The maximum thermal stability was seen in the composite with 0% fiber composition. While the most unstable composite is at 20% fiber composition with a 5% weight loss at 164.47^oC and 10% at 278.27^oC.

Keywords

Plastic Waste; Compoiste; Teki Grass; Thermal Stability; TGA

Full Text:

PDF

References

Y. Gu and Q.-C. Ran, “Chapter 28 - Polybenzoxazine/Fiber Composites,” in Handbook of Benzoxazine Resins, H. Ishida and T. Agag, Eds., Amsterdam: Elsevier, 2011, pp. 481–494. doi: https://doi.org/10.1016/B978-0-444-53790-4.00073-4.

Rout, R. K. Nayak, and S. Praharaj, “Chapter 13 - Aerospace and vehicle industry,” in Handbook of Polymer Nanocomposites for Industrial Applications, C. M. Hussain, Ed., Elsevier, 2021, pp. 399–417. doi: https://doi.org/10.1016/B978-0-12-821497-8.00013-7.

Kementerian Lingkungan Hidup dan Kehutanan, “Sistem Informasi Pengelolaan Sampah Nasional (SIPSN).”

J. Nyika and M. Dinka, “Recycling plastic waste materials for building and construction Materials: A minireview,” Mater Today Proc, vol. 62, pp. 3257–3262, 2022, doi: 10.1016/j.matpr.2022.04.226.

J. P. Carey, “1 - Introduction to braided composites,” in Handbook of Advances in Braided Composite Materials, J. P. Carey, Ed., Woodhead Publishing, 2017, pp. 1–21. doi: https://doi.org/10.1016/B978-0-08-100369-5.00001-5.

M. K. Egbo, “A fundamental review on composite materials and some of their applications in biomedical engineering,” Journal of King Saud University - Engineering Sciences, vol. 33, no. 8, pp. 557–568, 2021, doi: https://doi.org/10.1016/j.jksues.2020.07.007.

R. F. Gibson, Principles of Composite Material Mechanics. CRC Press, 2007. doi: 10.1201/9781420014242.

G. Sumithra, R. N. Reddy, G. Dheeraj Kumar, S. Ojha, G. Jayachandra, and G. Raghavendra, “Review on composite classification, manufacturing, and applications,” Mater Today Proc, 2023, doi: https://doi.org/10.1016/j.matpr.2023.04.637.

A. Karimah et al., “A review on natural fibers for development of eco-friendly bio-composite: characteristics, and utilizations,” Journal of Materials Research and Technology, vol. 13, pp. 2442–2458, 2021, doi: https://doi.org/10.1016/j.jmrt.2021.06.014.

K. Begum and Md. A. Islam, “Natural fiber as a substitute to synthetic fiber in polymer composites: A review,” Research Journal of Engineering Sciences, vol. 2, pp. 46–53, Jan. 2013.

Rohman Sidik, “Studi Pengaruh Penambahan Polypropylene Dan Low Density Polyethylene Terhadap Sifat Fisik Dan Mekanik Wood Plastic Composite Untuk Aplikasi Genteng Ramah Lingkungan,” https://repository.its.ac.id/, 2018.

A.-T. Yenny, S. Brandon, and C. Carolina, “Residual composite materials with applications in the industry of the construction,” in Journal of Physics: Conference Series, 2020. doi: 10.1088/1742-6596/1541/1/012005.

K. M. F. Hasan et al., “Sustainable bamboo fiber reinforced polymeric composites for structural applications: A mini review of recent advances and future prospects,” Case Studies in Chemical and Environmental Engineering, vol. 8, p. 100362, 2023, doi: https://doi.org/10.1016/j.cscee.2023.100362.

R. Wirawan, R. D. Pasaribu, D. Permatasari, and H. H. Sutrisno, “Stabilitas termal komposit eceng gondok (Eichhornia crassipes) dengan matriks HDPE,” in Proceeding seminar nasional tahunan teknik mesin XI (SNTTM XI) & thermofluid IV Universitas Gadjah Mada (UGM), Yogyakarta, 2012.

Ts. Dr. S. A. Farhan, F. Ismail, O. Kiwan, N. Shafiq, N. Husna, and A. I. Abd Hamid, “Effect of Roof Tile Colour on Heat Conduction Transfer, Roof-Top Surface Temperature and Cooling Load in Modern Residential Buildings under the Tropical Climate of Malaysia,” Sustainability, vol. 13, p. 4665, Apr. 2021, doi: 10.3390/su13094665.

M. L. Hakim And F. I. D. A. Nur’aini, “Skripsi–Tk 141581 Pengolahan Limbah Plastik Dengan Metode Mix Plastic Softening Agregate Untuk Meningkatkan Ketahanan Dan Kualitas Aspal Beton (Laston) Ramah,” 2018.

S. Sivapalan And P. Jeyadevan, “Physico-Chemical And Phyto-Chemical Study Of Rhizome Of Cyperus rotundus LINN,” International Journal of Pharmacology and Pharmaceutical Technology, pp. 42–46, Jan. 2017, doi: 10.47893/IJPPT.2017.1022.

Z. Millenio, F. Paundra, H. T. Yudhistira, E. Pujiyulianto, and I. Prabowo, “Pengaruh Perlakuan Alkali Terhadap Kekuatan Tarik Bahan Komposit Serat Rumput Teki,” Journal of Applied Mechanical Technology, vol. 1, pp. 10–15, Nov. 2022, doi: 10.31884/jamet.v1i1.5.

N. Shafa, D. Rhakasywi, and F. Fahrudin, “Analysis on The Influence of Sollar Irradiation And Rotational Speed of Centrifugal Submersible Pumps Efficiency in Solar Water Pump Systems Technology,” Journal of Applied Science, Engineering, Technology, and Education, vol. 5, no. 2, pp. 159–173, Dec. 2023, doi: 10.35877/454RI.asci2070.

K. Król-Morkisz and K. Pielichowska, “13 - Thermal Decomposition of Polymer Nanocomposites With Functionalized Nanoparticles,” in Polymer Composites with Functionalized Nanoparticles, K. Pielichowski and T. M. Majka, Eds., Elsevier, 2019, pp. 405–435. doi: https://doi.org/10.1016/B978-0-12-814064-2.00013-5.

C. Beyler and M. Hirschler, “Thermal decomposition of polymers,” SFPE Handbook of Fire Protection Engineering, vol. 2, Jan. 2002.

W. Zhang, X. Li, and R. Yang, “Pyrolysis and fire behaviour of epoxy resin composites based on a phosphorus-containing polyhedral oligomeric silsesquioxane (DOPO-POSS),” Polym Degrad Stab, vol. 96, no. 10, pp. 1821–1832, 2011.

DOI: http://dx.doi.org/10.12962/j25481479.v9i2.20340