SHEAR BEHAVIOUR ANALYSIS OF REINFORCED CONCRETE BEAM USING NON-LINEAR FINITE ELEMENT SIMULATION

Rahmat Dwi Sutrisno, Harun Alrasyid, Wahyuniarsih Sutrisno

Abstract


This paper investigates shear behaviour of reinforced concrete using multi-surface plasticity model. This analysis uses nonlinear finite element simulation using 3D-NLFEA finite element package. The experimental data adopted from the results of experimental test on eighteen beams where nine beams carried out by Bresler and Scordelis in 1963 and similar nine beams carried out by Vecchio and Shim in 2004. The constitutive model for the concrete material which used in this simulation is based on the plasticity-fracture model and considered the tension stiffening effect for the concrete. The result of the numerical simulation latter compared with the experimental test including load-deflection response, cracking pattern, and failure mode. Based on the analysis result, it was found that the load-deflection response shows slightly higher response compared with the experimental result. However, the cracking pattern and failure mode of the beam shows good result which is in compliance with the experimental test.

Keywords


Shear failure, plasticity-fracture model, nonlinear finite element, 3D-NLFEA

Full Text:

PDF

References


S. B. Bhide and M. P. Collins, “Influence of axial tension on the shear strength of transversally reinforced concrete beams,” ACI Struct. J., vol. 86, no. 5, pp. 570–581, 1989, doi: 10.1002/suco.202000278.

A. Tambusay, P. Suprobo, B. Suryanto, and W. Don, “Application of nonlinear finite element analysis on shear-critical reinforced concrete beams,” J. Eng. Technol. Sci., vol. 53, no. 4, 2021, doi: 10.5614/j.eng.technol.sci.2021.53.4.8.

B. Il Bae, J. H. Chung, H. K. Choi, H. S. Jung, and C. S. Choi, “Experimental study on the cyclic behavior of steel fiber reinforced high strength concrete columns and evaluation of shear strength,” Eng. Struct., vol. 157, no. December 2017, pp. 250–267, 2018, doi: 10.1016/j.engstruct.2017.11.072.

A. Sharma, R. Eligehausen, and J. Hofmann, “Seismic Assesment of Poorly Designed RC Frame Structures Seismic Assesment of Poorly Designed RC Frame Structures Considering Joint,” no. November, 2014, doi: 10.13140/2.1.2516.9608.

K. V. Duong, S. A. Sheikh, and F. J. Vecchio, “Seismic behavior of shear-critical reinforced concrete frame: Experimental investigation,” ACI Struct. J., vol. 104, no. 3, pp. 304–313, 2007, doi: 10.14359/18620.

M. M. Ziara, D. Haldane, and S. Hood, “Proposed changes to flexural design in BS 8110 to allow over-reinforced sections to fail in a ductile manner,” Mag. Concr. Res., vol. 52, no. 6, pp. 443–454, 2000, doi: 10.1680/macr.2000.52.6.443.

M. P. Collins, E. C. Bentz, E. G. Sherwood, and J. K. Wight, “Where is shear reinforcement required? review of research results and design procedures.,” ACI Struct. J., vol. 106, no. 4, p. 556, 2009.

A. Pimanmas and K. Maekawa, “Finite element analysis and behaviour of pre-cracked reinforced concrete members in shear,” Mag. Concr. Res., vol. 53, no. 4, pp. 263–282, 2001, doi: 10.1680/macr.53.4.263.51365.

B. Bujadham and K. Maekawa, “the Universal Model for Stress Transfer Across Cracks in Concrete,” Doboku Gakkai Ronbunshu, vol. 1992, no. 451, pp. 277–287, 1992, doi: 10.2208/jscej.1992.451_277.

B. Suryanto, K. Nagai, and K. Maekawa, “Modeling and analysis of shear-critical ECC members with anisotropic stress and strain fields,” J. Adv. Concr. Technol., vol. 8, no. 2, pp. 239–258, 2010, doi: 10.3151/jact.8.239.

B. Suryanto, K. Nagai, and K. Maekawa, “Smeared-crack modeling of R/ECC membranes incorporating an explicit shear transfer model,” J. Adv. Concr. Technol., vol. 8, no. 3, pp. 315–326, 2010, doi: 10.3151/jact.8.315.

A. Belarbi and T. T. C. Hsu, “Constitutive laws of concrete in tension and reinforcing bars stiffened by concrete,” ACI Struct. J., vol. 91, no. 4, pp. 465–474, 1994, doi: 10.14359/4154.

H. Shima, L. L. Chou, and H. Okamura, “Micro and Macro Models for Bond in Reinforced Concrete.,” Journal of the Faculty of Engineering, University of Tokyo, Series B, vol. 39, no. 2. pp. 133–194, 1987.

B. Piscesa, M. M. Attard, D. Prasetya, and A. K. Samani, “Modeling cover spalling behavior in high strength reinforced concrete columns using a plasticity-fracture model,” Eng. Struct., vol. 196, no. June, p. 109336, 2019, doi: 10.1016/j.engstruct.2019.109336.

F. J. Vecchio and M. P. Collins, “Modified Compression-Field Theory for Reinforced Concrete Elements Subjected To Shear.,” Journal of the American Concrete Institute, vol. 83, no. 2. pp. 219–231, 1986, doi: 10.14359/10416.

F. J. Vecchio and W. Shim, “Experimental and Analytical Reexamination of Classic Concrete Beam Tests,” J. Struct. Eng., vol. 9445, no. April 2004, pp. 1562–1569, 2004, doi: 10.1061/(ASCE)0733-9445(2004)130.

B. Piscesa, M. M. Attard, and A. K. Samani, “3D Finite element modeling of circular reinforced concrete columns confined with FRP using a plasticity based formulation,” Compos. Struct., vol. 194, pp. 478–493, 2018, doi: 10.1016/j.compstruct.2018.04.039.

U. Ayachit, “The ParaView Guide: A Parallel Visualization Application,” 2015.

B. Piscesa, M. M. Attard, A. K. Samani, and S. Tangaramvong, “Plasticity constitutive model for stress-strain relationship of confined concrete,” ACI Mater. J., vol. 114, no. 2, pp. 361–371, 2017, doi: 10.14359/51689428.

B. Piscesa, M. M. Attard, and A. K. Samani, “A lateral strain plasticity model for FRP confined concrete,” Compos. Struct., vol. 158, pp. 160–174, 2016, doi: 10.1016/j.compstruct.2016.09.028.

P. Menetrey and K. J. Willam, “92-S30.pdf,” no. 92, pp. 311–318, 1996.

M. M. Attard and S. Setunge, “Stress-strain relationship of confined and unconfined concrete,” ACI Mater. J., vol. 93, no. 5, pp. 432–442, 1996, doi: 10.14359/9847.

A. K. Samani and M. M. Attard, “A stress-strain model for uniaxial and confined concrete under compression,” Eng. Struct., vol. 41, pp. 335–349, 2012, doi: 10.1016/j.engstruct.2012.03.027.

CEB-FIP, “CEB FIP model code 1990.” p. 462, 1990.

M. P. Martins, C. S. Rangel, M. Amario, J. M. F. Lima, P. R. L. Lima, and R. D. Toledo Filho, “Modelling of tension stiffening effect in reinforced recycled concrete,” Rev. IBRACON Estruturas e Mater., vol. 13, no. 6, pp. 1–21, 2020, doi: 10.1590/s1983-41952020000600005.

V. Červenka and J. Červenka, “Atena Theory Updated,” pp. 1–33, 2018.

B. Piscesa, H. Alrasyid, D. Prasetya, and D. Iranata, “Numerical Investigation of Reinforced Concrete Beam Due to Shear Failure,” IPTEK J. Technol. Sci., vol. 31, no. 3, p. 373, 2021, doi: 10.12962/j20882033.v31i3.7385.

B. B. and A. C. Scordelis, “Shear strength of reinforced concrete beams,” J. Am. Concr. Inst., no. 3, pp. 51–74, 1963.




DOI: http://dx.doi.org/10.12962/j20861206.v37i1.12602

Refbacks

  • There are currently no refbacks.



Journal of Civil Engineering is licensed under a Creative Commons Attribution-ShareAlike 4.0 International License.

View My Stats