.jpg)
Experimental Evaluation of Heat of Hydration in Concrete Incorporating Supplementary Cementitious Materials
Abstract
This research aims to study the impact of supplementary cementitious materials on the heat of hydration of concrete. The experimental tests were performed for concrete with three size variations and seven variations of supplementary cementitious materials (SCMs) to investigate its impact on the heat of hydration. The SCMs used in this research mainly come from industrial waste materials. Fly ash (FA), ground bottom ash (GBA), and silica fume (SF) were the waste materials used in this research. Tests were carried out for seven days for each variation to observe the effect of volume changes and the addition of SCMs on the change in concrete temperature. The experimental results indicated a direct correlation between concrete volume and maximum temperature, with notable variations in temperature distribution across the concrete mass. Typically, the highest temperature was observed at the core of the concrete. Fly ash (FA) and bottom ash (BA) demonstrated an inverse relationship between their content as supplementary cementitious materials (SCMs) and the maximum temperature achieved. Increasing the proportion of FA and BA in the concrete mixture resulted in a reduction of the hydration temperature. Additionally, silica fume (SF) was found to accelerate the hydration rate, though its efficacy in lowering the heat of hydration was significant only when its content exceeded 5%.
Keywords
Full Text:
PDFReferences
S. G. Kim, ‘Effect of heat generation from cement hydration on mass concrete placement’, Graduate Theses and Dissertations, Iowa State University, 2010.
Rochaeti, J. Endawati, L. Diasti Dessi Widuri, and Moeljono, ‘Pengaruh Panas Hidrasi Beton Dengan Semen Type II Terhadap Ketebalan Elemen Beton’, Jurnal Teknik Sipil & Perencanaan, vol. 16, no. 2, pp. 183–194, 2014.
D. S. Atrushi, ‘Tensile and Compressive Creep of Early Age Concrete: Testing and Modelling’, Doctoral Thesis, The Norwegian University of Science and Technology, Trondheim, Norway, 2003.
S. Han, Y. Liu, Y. Lyu, J. Liu, and N. Zhang, ‘Numerical simulation investigation on hydration heat temperature and early cracking risk of concrete box girder in cold regions’, Journal of Traffic and Transportation Engineering (English Edition), vol. 10, no. 4, pp. 697–720, Aug. 2023.
E. John and B. Lothenbach, ‘Cement hydration mechanisms through time – a review’, Journal of Material Science, vol. 58, no. 24, pp. 9805–9833, 2023.
F. Hamdi et al., Teknologi Beton, vol. 1. Makasar: CV. Tohar Media, 2022.
S. H. Kosmatka and M. L. Wilson, Design and control of concrete mixtures : the guide to applications, methods, and materials, 15th edition,. Skokie, Illinois, USA: Portland Cement Association, 2011.
D. Ndahirwa, H. Zmamou, H. Lenormand, and N. Leblanc, ‘The role of supplementary cementitious materials in hydration, durability and shrinkage of cement-based materials, their environmental and economic benefits: A review’, Cleaner Materials, vol. 5, pp. 100–123, Sep. 2022.
ACI Committee 232, Report on the use of fly ash in concrete (ACI 232.2R-18). 2018.
B. W. Langan, K. Weng, and M. A. Ward, ‘Effect of silica fume and fly ash on heat of hydration of Portland cement’, Cement and Concrete Research, vol. 32, pp. 1045–1051, 2002.
P. R. de Matos, R. Junckes, E. Graeff, and L. R. Prudêncio, ‘Effectiveness of fly ash in reducing the hydration heat release of mass concrete’, Journal of Building Engineering, vol. 28, Mar. 2019.
S. A. Mangi et al., ‘A review on potential use of coal bottom ash as a supplementary cementing material in sustainable concrete construction’, International Journal of Integrated Engineering, vol. 10, no. 9, pp. 127–135, 2018.
P. Khongpermgoson et al., ‘The mechanical properties and heat development behavior of high strength concrete containing high fineness coal bottom ash as a pozzolanic binder’, Construction and Building Materials, vol. 253, pp. 119–239, 2020.
ASTM C311-02, Standard Test Methods for Sampling and Testing Fly Ash or Natural Pozzolans for Use in Portland-Cement Concrete. ASTM International, 2003.
T. A. Do, D. Verdugo, M. Tia, and T. T. Hoang, ‘Effect of volume-to-surface area ratio and heat of hydration on early-age thermal behavior of precast concrete segmental box girders’, Case Studies in Thermal Engineering 28, 2021.
Y. Amine, N. Leklou, and O. Amiri, ‘Effect of supplementary cementitious materials (scm) on delayed ettringite formation in heat-cured concretes’, Energy Procedia, Elsevier Ltd, 2017, pp. 565–570.
N. Savadogo et al., ‘Hydration and physico-mechanical characterization of bottom ash-based cement’, Construction and Building Materials, vol. 434, 2024.
N. Ankur and N. Singh, ‘Performance of cement mortars and concretes containing coal bottom ash: A comprehensive review’, Renewable and Sustainable Energy Reviews, vol. 149. Elsevier Ltd, 2021.
N. De Belie, M. Soutsos, and E. Gruyaert, ‘Properties of Fresh and Hardened Concrete Containing Supplementary Cementitious Materials’, State-of-the-Art Report of the RILEM Technical Committee 238-SCM, 2018.
M. Giménez Fernández and J. M. Lees, ‘Symmetric prism characterisation test to infer heat generation and heat conduction properties of concrete’, Construction and Building Materials, vol. 425, 2024.
L. E. Al-Hasani et al., ‘Prediction of heat of hydration of cementitious systems using Gaussian process regression enables mass concrete thermal modeling’, Materials and Structures, 2023.
Y. Ballim and P. C. Graham, ‘The effects of supplementary cementing materials in modifying the heat of hydration of concrete’, Materials and Structures, vol. 42, no. 6, pp. 803–811, 2009.
M. I. Al Biajawi, R. Embong, K. Muthusamy, N. Ismail, and I. I. Obianyo, ‘Recycled coal bottom ash as sustainable materials for cement replacement in cementitious Composites: A review’, Construction and Building Materials 338, 2022.
C. Argiz, M. Á. Sanjuán, and E. Menéndez, ‘Coal Bottom Ash for Portland Cement Production’, Advances in Materials Science and Engineering, 2017.
J. Liu, Y. Zhang, R. Liu, and B. Zhang, ‘Effect of fly ash and silica fume on hydration rate of cement pastes and strength of mortars’, Journal Wuhan University of Technology, Materials Science Edition, vol. 29, no. 6, pp. 1225–1228, 2014.
DOI: http://dx.doi.org/10.12962/j20861206.v39i2.21651
Refbacks
- There are currently no refbacks.
Journal of Civil Engineering is licensed under a Creative Commons Attribution-ShareAlike 4.0 International License.