Simulation of Double Walled Pipe Impact to Crude Oil Flow in Subsea Pipeline System
Abstract
Crude oil contains mixed of hydrocarbons, the most commonly found molecules are alkanes (paraffins), cycloalkanes (naphthenes), aromatic hydrocarbons, or more complicated chemicals. In the process of taking crude oil in subsea pipeline system with depth 1200 meters, the contents of crude oil like sulfur, paraffin, asphalt could deposit in the wall of the pipe because of the different temperature between crude oil and wall of the pipe. The deposition can make blockage to the pipe and cause crude oil flow to be slow or stop. In this bachelor thesis, will be design double walled pipe for Subsea pipeline system with depth 1200 meters and simulation double walled pipe to knowing the impact of double walled pipe to crude oil flow in Subsea with depth 1200 meters. Based on the simulation that has been done, using double walled pipe could stabilize the temperature between crude oil and wall of the pipe. It shows that the average of temperature decrease using double walled pipe is only 0.125 K for 12 meters. So, it could get the conclusion based on the simulation of double walled pipe that the impact to crude oil flow is there’s no blockage in the pipe and the crude oil flow will steady.
Keywords
Full Text:
PDFReferences
Venture Engineering & Construction, “Double Walled Piping System”, p. 1, Pittsburgh.
About Pipelines, “Would double walled pipelines help prevent spills?”, 2016, Available: https://www.aboutpipelines.com/blog/would-double-walled-pipelines-help-prevent-spills/.
Mark Carruth, “Design Optimization Case Study: Deep Sea Linepipe”, University of Cambridge, pp. 1-8.
Qiang Bai, Young Bai, “Subsea Pipeline Design, Analysis, and Installation”, 2014, Houston USA.
Yunus A. Cengeland Michael A. Boles, “Thermodynamics: An Engineering Approach Fifth Edition”, McGraw-Hill, 2006, pp. 93- 5.
Michael Kelly, “Pipe Insulation (Hot & Cold) Material Selection & Application”, TRADE OF Industrial Insulation, Phase 2, pp. 3-6, 2014
ANSYS,“Fluids”,2017,Available: http://www.ansys.com/products/fluids.
cen72367_ch08.qxd, “Flow In Pipes”, University of San Carlos, 2004
Kevin Cooke, “ What is the average temperature of crude oil when it is extracted”, Quora, 2015, Available: https://www.quora.com/What-is-the-average-temperature-of-crude-oil-when-it-is-extracted.
Abraham K. George and Ram N Singh and SayyadulArafin, “Equation of State of Crude Oil Samples”, 2013
Koto J, 2016, “Review on Deep Water Flow lines of Gumusut – Kakap, Malaysia”, Department of Aeronautical, Automotive and Ocean Engineering, University Teknologi Malaysia, Johor Bahru, Malaysia & Ocean and Aerospace Engineering
Research Institute, Indonesia
DOI: http://dx.doi.org/10.12962/j25481479.v2i3.2721
Refbacks
- There are currently no refbacks.
| |||
|
|
|
|
P-ISSN: 2541-5972
E-ISSN: 2548-1479
IJMEIR journal published by Department of Marine Engineering, Faculty of Marine Technology, Institut Teknologi Sepuluh Nopember Surabaya Indonesia under licenced Creative Commons Attribution-ShareAlike 4.0 International Licence. Based on https://iptek.its.ac.id/index.php/ijmeir/