Noise Reduction in Ship Engine Room by Optimisation of Muffler Design
Abstract
Noise level onboard, particularly in the engine room, requires a careful monitor to not causing any disruption or discomfort to the shipboard environment. For monitoring purposes, an appropriate alternative system can be applied if the noise level exceeds the limit set by applicable regulations such as IMO, ABS, and LR. The current research uses computational methods to map noise contours in the engine room and recommends some muffler models to reduce the noise level in the MV Natuna Express engine room. Based on the field measurement, the noise level exceeds the Standards value at a maximum of 110 dB. Mapping and designing of the muffler models were based on the measurement data. Simulation results show that greater transmission loss hence noise reduction is affected significantly by the expansion of muffler chamber length and diameter. Modification of the muffler chamber using plywood and the tailpipe on both ME ON Generator ON and ME OFF Generator ON conditions respectively reduce the noise approximately by 24.94 dB and 10.50 dB.
Keywords
Full Text:
PDFReferences
Dodi Apri Haryanto, "Experiment Study of Noise Reduction Diesel Exhaust Gas with Wet Damping Method," Surabaya, Sepuluh Nopember Institute of Technology, 2012.
Gabriel Yusian Gadung, "Noise Level Analysis in Machine Rooms and Accommodation Spaces of Ketapang-Gilimanuk Crossing Boat Spaces," Surabaya, Ten November Institute of Technology, 2017.
Ratih Dwilestari, "Noise Level Control in the KNP 329 crew crew due to the engine," in the 2nd Joint International Conference on "Sustainable Energy and Environment (SEE 2006), Bangkok, 2014.
M. F. Fachrul, W. E. Yulyanto, and A. Merya, "Desain penyusunan peredam kebisingan menggunakan plywood, busa, tray dan sabut pada sumber statis," Makara Journal of Technology, vol. 15, no. 1, p. 150888, 2011.
Rindianti Wibowo, "Analysis of Engine Room Noise Levels on KMP Ships. Muria, "Semarang, Diponegoro University, 2014.
MSC 91/22 / Add.1 Annex I. (2012), "Code On Noise Levels On Boards Ships"
C. R. Kothari, Research methodology: Methods and techniques. New Age International, 2004.
Sunarsih, "Four Quadrant Thrust Generation Model with Bounded Dynamic Wake and Thrust Deduction Fractions," Doctoral Degree, Universiti Teknologi Malaysia, 2018.
B.J Smith, R.J Peters and S. Owen "Accoustic and Noise Control 2nd Edition," London, Longman Group UK, 1996.
A.P Peterson, "Handbook of Noise Measurements," In the 9th Edition, General Radion Inc., 1980.
Noise Problem Analysis Part 2.pdf
Odio Setyawan, "Analisa Tingkat Kebisingan Di Kamar Mesin Pada Kapal Cargo KM. Caraka Jaya Niaga III-17 Terhadap Kondisi Kerja Karyawan Dan Anak Buah Kapal (ABK)," Semarang, Universitas Diponegoro, 2012.
Iwan Yahya, "Dasar-dasar Pengukuran kebisingan," Surakata, Universitas Sebelas Maret, 2002.
Eko Julianto Sasono, "Pengukuran Tingkat Kebisingan Pada Kapal Coaster," Semarang, Universitas Diponegoro, 2007.
Gun Gumelar Somantri, "Tingkat Kebisingan Pada Kapal Penangkap Ikan (Studi Kasus Pada Modern Boat Lift Net KM Omega Jaya Di Pulo Ampel Serang, Banten," Bandung, Institut Teknologi Bandung, 2014.
Rilwanu Ahmad, "Model Analitik Muffler Absorptive Pada Ventilasi Udara," Surabaya, Institut Teknologi Sepuluh Nopember, 2015.
Risna Dewi Enisa, "Intesitas Kebisingan Pada Kapal Gillnet di Pangkalan Pendaratan Ikan (PPI) Binuangeun Lebak Banten,"Bandung, Bandung Institute of Technology, 2016.
Arif Syaiful, "Analisis Tingkat Kebisingan Pada Kamar Mesin dan Ruang Akomodasi Kapal Ro-Ro Penyebrangan Ketapang – Gilimanuk," Surabaya, Sepuluh Nopember Institute of Technology, 2004.
Yudo Hartono, "Analisis Getaran dan Kebisingan Pada Motor Diesel Dengan Menggunakan Bahan Bakar Jelantah Ethyl Ester," Semarang, Universitas Diponegoro, 2012.
Didik Kristiawan, "Analisis Kebisingan Sistem Ventilasi Kamar Mesin KR. Baruna Jaya VII ," Surabaya, Sepuluh Nopember Institute of Technology, 2004.
Beny Cahyono, "Analisis Getaran dan Kebisingan Pada Motor Diesel Dengan Menggunakan Bahan Bakar Jelantah Ethyl Ester," Surabaya, Sepuluh Nopember Institute of Technology, 2002.
Syawaluddin, "Pengujian Desain Muffler Untuk Mengurangi Emisi Suara Pada Mesin Diesel," Surabaya, Sepuluh Nopember Institute of Technology, 2004.
Mastria Suandika, "Studi Awal Emisi Kebisingan Knalpot Dengan Profil Silinder Yang Dibuat Dari Material Titanium DenganMenggunakan Simulasi Metode Elemen Hingga," Medan, University of Sumatera Utara, 2007.
Setiyo huboyo et al, "Buku Ajar Pengendalian Bising dan Bau," Semarang, University of Sumatera Utara, 2008. Universitas Diponegoro.
Nono Triyono, "Studi Eksperimen Peredaman Kebisingan Gas Buang Motor Diesel Dengan Metode Peredaman Basah," Semarang, University of Sumatera Utara, 2005. Universitas Diponegoro.
DOI: http://dx.doi.org/10.12962/j25481479.v5i4.5567
Refbacks
- There are currently no refbacks.
| |||
|
|
|
|
P-ISSN: 2541-5972
E-ISSN: 2548-1479
IJMEIR journal published by Department of Marine Engineering, Faculty of Marine Technology, Institut Teknologi Sepuluh Nopember Surabaya Indonesia under licenced Creative Commons Attribution-ShareAlike 4.0 International Licence. Based on https://iptek.its.ac.id/index.php/ijmeir/