Modeling and Control of Anti-Rolling Gyro System to Stabilize Single-Track Vehicle

Buntheng Chhornand, Unggul Wasiwitono

Abstract


Two-wheeled vehicle has many advantages such as small size, more efficiency, and more maneuverable. These advantages come at the lack of stability and safety. To improve the stability and safety of a two-wheeled vehicle, the Control Moment Gyroscopic Stabilization is considered. This system is composed to generate counteracting roll stabilizing torque. In this study, the system of gyroscopic stabilizer is simulated and validated to be implemented into a two-wheeled vehicle. Proportional-Integral-Derivative (PID) controller is designed to control the gimbal for generating the balancing torque. The performance of the proposed controller is evaluated through simulation for non-linear cases. The result of the non-linear model confirms a good balance in terms of rapid response.

Full Text:

PDF

References


R. D. Harris and J. S. Wilkinson, “Waveguide surface plasmon resonance sensor,” Sensors and Actuators, vol. 29, no. 1–3, pp. 261–267, 1995.

N. M. Kassim, M. H. Ibrahim, A. B. Mohammad, and M. Yacob, “Polymer Based Multimode Interfence Optical Couplerol,” in in Recent Developments in Polymer Waveguides and Devices, 2008, p. 41.

T. Tahar, “Low loss Sol-Gel Thin Film for Waveguide Applications,” Coatings, vol. 3, pp. 49–58, 2013.

J. D. B. Bradley et al., “Submicrometer-wide amorphous and polycrystalline anatase TiO 2 waveguides for microphotonic devices,” Opt. Express, vol. 20, no. 21, pp. 8336–8346, 2012.

R. T. Ako et al., “DSSCs with ZnO@ TiO2 Core--Shell Photoanodes Showing Improved Voc: Modification of Energy Gradients and Potential Barriers with Cd and Mg Ion Dopants,” Sol. Energy Mater. Sol. Cells, vol. 157, pp. 18–27, 2016.

S. E. M. & S. Cells, “TiO2 nanoparticles optimized for photoanodes tested in large area Dye-sensitized solar cells (DSSC),” vol. 153, pp. 108–116, 2016, doi: http://dx.doi.org/10.1016/j.solmat.2016.04.0040927-0248/&2016.

N. Tasić et al., “Mesoporous films prepared from synthesized TiO2 nanoparticles and their application in dye-sensitized solar cells (DSSCs),” Electrochim. Acta, vol. 210, pp. 606–514, 2016.

J. of C. and I. Science, “A CdS_ZnSe_TiO2 nanotube array and its visible light photocatalytic activities _ Elsevier Enhanced Reader.pdf,” Sci. J. Colloid Interface, vol. 462, pp. 389–396, 2016, doi: http://dx.doi.org/10.1016/j.jcis.2015.10.0050021.

S. A. Yasin, “Characterization Prototype Multimode Interference Device (MMI) For Optical Power,” Inst. Teknol. Sepuluh Nop., 2013.

Y. R. Meifina, “Study About Application of Slab Waveguide Based on Polymethyl Methacrylate (PMMA) Using Spin Coating Technique As Mass Gauge,” 2013.

Rinawati, “Fabrication and Characterization Directional Coupler Slab Structure Based on Polystyrene and Polymethyl Methacrylate (PMMA) Polimer,” Physics, Institut Teknologi Sepuluh Nopember, Surabaya, 2009.

“Morphological, structural and ellipsometric investigations of Cr doped TiO2 thin films prepared by sol–gel and spin coating,” Ceram. Int., vol. 42, pp. 10599–10607, 2016, doi: lhttp://dx.doi.org/10.1016/j.ceramint.2016.03.145.




DOI: http://dx.doi.org/10.12962/j23546026.y2020i6.8903

Refbacks

  • There are currently no refbacks.


View my Stat: Click Here

Creative Commons License
This work is licensed under a Creative Commons Attribution-ShareAlike 4.0 International License.