Engine Torque Control of SI Engine using Linear Quadratic Integral Tracking (LQIT) Optimal Control

Aris Triwiyatno, Mohammad Nuh, Ari Santoso, I Nyoman Sutantra


Due to the needs of improving fuel economy and reducing emissions, it is increasingly important to achieve control over robustness behavior and meet performance objectives over the life of the vehicle. This requires the development of high performance and optimal power train controllers. The performance objectives are often conflicting, or at least interrelated. One way to potentially meet these performance requirements is to introduce a method of controlling engine torque of Spark Ignition (SI) engine using Linear Quadratic Integral Tracking (LQIT) optimal control. The goal is to develop simple algorithms which can control engine torque well, thus providing fuel control more efficient and simultaneously improving engine performance due to the needs of the driver based on throttle opening information. In this case, spark ignition engine with automatic transmission simulation model is used to meet a good performance under this controller design.


engine torque; LQIT optimal control; SI engine

Full Text:



A. Nugroho, “Desain Kompensator Sistem Pengaturan Kecepatan pada Spark Ignition Engine dengan Menggunakan QFT.” Bachelor Final Project, Dept. of Electrical Engineering, Faculty of Industrial Technology, ITS, Surabaya, Indonesia, 2004.

A. Salim. “Desain Kompensator sebagai Kontrol Robust pada Sistem Pengapian Spark Ignition Engine,” Master Thesis, Dept. of Electrical Engineering, Faculty of Industrial Technology, ITS, Surabaya, Indonesia, 2004.

Irianto. “Analisis Sistem Pengaturan Kecepatan Spark Ignition Engine Menggunakan Kontrol Robust MIMO,” Master Thesis, Dept. of Electrical Engineering, Faculty of Industrial Technology, ITS, Surabaya, Indonesia, 2005.

D. Khiar, J. Lauber, T. Floquet, G. Colin, T.M. Guerra, Y. Chamaillard, “Robust Takagi–Sugeno fuzzy control of a spark ignition engine,” Control Eng. Pract. Elsevier, vol.15, no.12,1446, 2007.

T. Nagata and M. Tomizuka, “Robust engine torque control by iterative learning control,” presented at American Control Conference, ACC '09, New Jersey, USA, p.2064, 2009.

N. Heintz, M. Mews, G. Stier, and A. Beaumont, “An Approach to Torque-Based Engine Management Systems,” SAE Technical Paper 2001-01-0269, doi:10.4271/2001-01-0269, 2001.

I. Kolmanovsky, M. Druzhinina, and J. Sun, “Nonlinear Torque and Air-to-Fuel Ratio Controller for Direct Injection Stratified Charge Gasoline Engines,” in Proceeding of AVEC, 5th Int'l Symposium on Advanced Vehicle Control, Michigan, p.1.

D. M. Lamberson, “Torque Management of Gasoline Engine,” Thesis Master, Mechanical Engineering, University of California at Berkeley, California, 2003.

A. Stefanopoulou, “Modeling and Control of Advanced Technology Engine,” Ph.D. Dissertation, Dept. of Electrical Engineering: Systems, University of Michigan, USA, 1996.

The MathWorks Inc.,“Using Simulink and Stateflow in Automotive Applications,” The MathWorks Inc., USA, 92, 1998.

M. Athans, “A Tutorial on the LQG/LTR Method,” in Proc. American Control Conference, ACC '86, vol.2, 1986, pp. 1289 -1296.

DOI: http://dx.doi.org/10.12962/j20882033.v22i4.80


  • There are currently no refbacks.

Creative Commons License

IPTEK Journal of Science and Technology by Lembaga Penelitian dan Pengabdian kepada Masyarakat, ITS is licensed under a Creative Commons Attribution-ShareAlike 4.0 International License.
Based on a work at https://iptek.its.ac.id/index.php/jts.