Analysis of Quality Improvement of Finishing Work in The Development of Puncak CBD Surabaya Apartment

Safira Damayanti, I Putu Wiguna

Abstract


The quality is one of the important factors in the success of construction project. In fact, cost of construction is vain until 6-15% because reworking and process of work is late. Wika Building Contractor have standart of quality, name is QPASS ( Quality Performance Assessment Support System ) for all projects. Puncak CBD Surabaya Apartment,is one of Wika Building Project that having lower quality standart value in 2018. In this study, the six sigma method with the DMAIC (Define, Measure, Analyze, Improve, Control) approach was used to improve low quality values. Starting with identify works with defect largest based on QPASS monthly report, then calculate the dominant defect using a level of sigma. The research results show the wall work having highest total number of defects. The wall work defect with sigma value under 3 level are joint of wall is not perpendicular, cracked plaster seen from 1.5 m distance and flaking paint. At the improve phase, determined the best action plan for handle cause factor of the three such defect. The best action was determined are do thickening and adjust the angle of wall for defect “Joint of wall is not perpendicular”, giving direction for workers about correct plaster mixture for defect “Cracked plaster seen from 1.5 m distance”, and cleaning of wall before painting for defect “ Flaking paint”.

Keywords


Quality; Six Sigma; DMAIC; Qpass; Defect of Finishing Work

Full Text:

PDF

References


D. Ashokkumar, “Study of quality management in construction industry,” Int. J. Innov. Res. Sci. Eng. Technol., pp. 36–43, 2014.

H. Gunaydin, “TQM in the Construction Industry,” 1995.

H. Ardhan and et al, “Evaluasi Pengerjaan Ulang (Rework) Pada Proyek Konstruksi Gedung Di Semarang,” J. Karya Tek. Sipil, pp. 93–106, 2015.

W. Ledbetter, “The quality performance management system: a blue print for implementation,” Austin, 1990.

K. Peter and F. Natassasanti, “Asesmen Kualitas Komponen Arsitektural TIGA Gedung Perkantoran di Yogyakarta dengan Prinsip - Prinsip CONQUAS dan Six Sigma,” 2018.

W. Kristanto, “Defect Analysis of Building Construction Works Building in Surabaya with Six Sigma Methode.,” Int. J. Innov. Sci. Reaserch Technol., 2018.

L. Yusuf and et al, “Penerapan Pendekatan Metode Six Sigma Dalam Penjagaan Kualitas Pada Proyek Konstruksi,” Makara Teknol., pp. 67–72, 2009.

Heizer and Render, Operation Management: Sustainability and Supply Chain Management. Jakarta: Salemba Empat, 2015.

V. Gaspersz, Total Quality Management. Jakarta: PT. Gramedia Pustaka Utama, 2002.

H. Ferdian and et al, “Penerapan Metode DMAIC dalam Peningkatan Acceptance Rate Untuk Ukuran Panjang Produk Bushing,” ComTech, vol. 3, pp. 938–995, 2012.




DOI: http://dx.doi.org/10.12962/j20882033.v30i3.5509

Refbacks

  • There are currently no refbacks.


Creative Commons License

IPTEK Journal of Science and Technology by Lembaga Penelitian dan Pengabdian kepada Masyarakat, ITS is licensed under a Creative Commons Attribution-ShareAlike 4.0 International License.
Based on a work at https://iptek.its.ac.id/index.php/jts.